Universal bar feeder Maestro 80 No Limits
The MAESTRO 80 NO LIMITS is an automatic bar feeder for bars from 10 to 80 mm for lathes with fixed headstock , ideal for those who are looking for very high performances and very high flexibility. The MAESTRO 80 NO LIMITS is the best synthesis of: maximising productivity, extreme flexibility, physical and cognitive ergonomics – all within a new look with modern design lines.
➜ Maestro 80 No Limits is INDUSTRY 4.0
ABACOS® (Adaptive BAr COntrol System)
Consisting of special self-adjusting bushings able to dampen the vibrations of the bar and tighten the bar pusher at the same time, with no need to change the guide channel.
HANDYLOQ® a VDC® (VIBRA-DAMP COLLET)
HANDYLOQ® is a IEMCA patented system used to quickly engage the collet into the rotary assembly, allowing the operator to replace the collet manually with no tools.
VDC® is an IEMCA patented collet that dampens the bar vibrations by reducing its oscillation amplitude. This new generation of VDC® reduces the bending and torsional stresses on the bar, separating the rotation of the bar from the motion of the rotary unit-collet system. The VDC® offers total flexibility to the customer, who will be able to adjust the diameter of the collet to the bar to work.
CLOSER THAN EVER BEFORE!
MAESTRO® is the bar feeder with the shortest installation distance. Thanks to the ABACOS® system, it is possible to use short bar pushers thus reducing the installation distance between bar feeder and lathe.
PRODUCTIVITY MAXIMIZATION
MAESTRO® sets no limits to your desire for efficiency. It allows to:
1. Reduce retooling times almost to zero.
2. Cut bar change time down to 30 seconds.
3. Reach the maximum speed allowed by your lathe with every configuration.
To change the diameter of the bar to work, it is sufficient to:
1. Set the new diameter on the operator panel: the magazine will adjust automatically.
2. Manually replace the collet using the HANDYLOQ® quick coupling system.
Round bars
10 – 80 mm
Hexagonal bars
10 – 65 mm
Square bars
10 – 50 mm
Bar length
1000 – 4200 mm
Fixed headstock
Yes
Mobile headstock
No
MP magazine available
Yes, 330 mm
UP magazine available
440 mm useful surface (that can be extended to 740 mm) + 3 bars on the chains
P magazine available
No
F magazine available
No
OAB magazine available
Yes, 2.5 tons
Remnant length
110 – 400 mm
Bar changeover time
30 sec
Bar weight
Max 180 kg
Bar feeder weight
Ver. 32 – 1800 kg
Number of spindles
1
Reversible magazines
Yes
Feed rate
500 mm/sec.
Return speed
1000 mm/sec.
Compressed air
6 bar
Installed power
2,3 kW
Operating voltage
230 / 400 Volt